How To Abort A Job; How To Adjust Speed; How To Bring The Hoop Out - Husqvarna Viking Platinum MN 1000 User Manual

HOW TO ABORT A JOB

This function is used to abort an embroidery job in process. This
process terminates the entire job.
1. Press the origin (1) icon. The following message will prompt,
"Terminate embroidery and return to the origin?"
2. Click OK. The frame will move to a center position and the design
will reset.

HOW TO ADJUST SPEED

This function is used to adjust the speed of the stitches incrementally.
The number displayed in red is the current speed of the embroidery
machine.
1. Press the increments icon (2).
2. Press the plus (+) or minus (-) button (3).
• If the increments button is displaying one (1) arrow, then the speed
can be reduced or increased by 10 stitches per minute.
• If the increments button is displaying two (2) arrows, then the
speed can be reduced or increased by 50 stitches per minute.

HOW TO BRING THE HOOP OUT

This function is used to bring the hoop from underneath the needles,
so the embroidery is accessible to the user. This function is mostly used
when doing appliques.
1. Press the hoop offset icon (4).
The embroidery hoop will move from underneath the needles.
2. Press the hoop offset icon (5).
The embroidery hoop will return the embroidery hoop back into
position.
1
2
3
4
5
COLOR TOUCH SCREEN – 41