Table of Contents
Advertisement
PREPARATION
UNPACK YOUR EMBROIDERY
MACHINE
It is recommended to keep all shipping materials.
Practice safety by using two (2) people to carry the
embroidery machine.
1. Carefully remove the box by pulling upwards, using the
cutouts found on the sides of the box.
2. Identify all of the accessories encased within the
exterior of the styrofoam surrounding the embroidery
machine.
3. Remove the accessories:
•
Cap driver
•
Thread stand
•
Flat hoop support
•
Toolbox
•
Ethernet cable
•
Cap station
•
Thread cone holders
•
Embroidery hoops
•
Connecting cable
•
Power cord
ADJUST AND SECURE YOUR EMBROIDERY MACHINE
To avoid accidents or injuries, lift the embroidery machine between two (2) people.
Keep the embroidery machine two inches (50 mm) away from the wall.
Do not block the embroidery machine's ventilation.
•
Set up the embroidery machine on top of a leveled,
balanced, and durable surface. Make sure to remove all
packaging materials from the embroidery machine.
•
Adjust the height of the base feet by rotating the
adjusting nuts (1) clockwise or counter clockwise. Once
desired height has been achieved, lock the base feet by
tightening the lock nut (2).
Make sure all feet have the same height.
•
Adjust the length of the display arm, by loosening the
adjusting knobs (3).
•
Tilt the display by loosening the panel adjusting knob
(4), then tighten it again to hold the panel in place.
!
4. Remove the styrofoam.
5. Remove the Velcro tie from the plastic bag covering the
embroidery machine.
6. Pull the plastic cover down.
7. Lift the embroidery machine from the bottom and
place it on top of the stand. Use caution.
8. Remove the protection film.
2
1
3
4
PREPARATIONS – 11
Advertisement
Table of Contents
