Thread Stand Assembly; Attaching The Thread Stand To The Machine - Husqvarna Viking Platinum MN 1000 User Manual

THREAD STAND ASSEMBLY

Assemble the thread rack by inserting a spool pin in each
hole. Put a sponge cushion onto each spool pin. If needed,
put a plastic thread reel onto each spool pin. The plastic
thread reels are used to help keep the thread spool in place
as the machine runs and/or when using larger spools.
ATTACHING THE THREAD
STAND TO THE MACHINE
1. Loosen the lower screws (A) on the thread stand
columns.
Lift off the thread stand.
2. Remove the lower lock nuts (B) on the thread stand
columns.
Place the thread rack onto the thread stand columns.
Replace and tighten the lower lock nuts (B) to the
thread stand columns.
If needed, also tighten the upper lock nuts (C).
3. Put the assembled thread stand back onto the machine.
Tighten the lower screws (A) on the thread stand
columns to secure the thread rack.
Loosen the upper screws (D) on the thread stand
columns to adjust the height of the thread stand
columns.
12 – PREPARATIONS
1
A
2
C
B
3
D