Images; Camranger Pt Hub And Tripod - CamRanger User Manual

• Intervalometer and Bulb commands are stored on the CamRanger hardware such that the
Mac does not need to remain on and connected.
• When an operaPon, command, or sejng is not available or not working the issue is ohen
related to the camera setup. For example:
• Toggling to AF is disabled if the camera lens switch is set to MF.
• Live view will fail on Canon cameras if Live View ShooPng is disabled in the camera's
menu.
• Capture fails because the removable media on the camera is full.
• For Canon cameras, the Live View focus mode within the camera's menu must be set to "Live
View".
• AdjusPng or viewing the number of brackePng shots is not currently supported. The display
assumes three shots. However, if the number of shots is actually 2, 5, 7, 9, etc. the bracket
amount is sPll correct it will just incorrectly display 3 shots.
• Some features are not supported by some cameras. For example conPnuous capture mode is
not supported on the Canon 40D and many Nikons do not support bulb shots. See the camera
capability matrix at www.CamRanger.com/supported-cameras/ for more detailed informaPon.
• If touch focusing does not work on a Canon camera, the likely cause is that the rear AF buUon
has been changed to some other funcPon and must be reset back to its default AF behavior.

Images

• The thumbnails are not downloaded unPl aher the image has been recorded to the camera's
card. On most cameras this is relaPvely quick. However, depending on the camera, speed of
removable media and number of shots taken in succession, there can be a lag.
• CamRanger can be used to view and download pictures captured through other means. So a
photographer could be capturing images, or a RF or light trigger could capture images and the
CamRanger applicaPon would automaPcally download the thumbnails.
• If shooPng to mulPple cards, ensure the playback card is set to the memory card of interest.
So if shooPng RAW to card one and JPG to card two and viewing the JPGs is desired, then set
the playback card to card number two.
CamRanger PT Hub and Tripod
• If the tripod head becomes unresponsive, securely reconnect the serial connector to the
tripod head.
• The speed of the tripod may vary depending on the weight of the camera and baUery life
of the tripod head.
• When using the CamRanger PT Hub, the CamRanger baUery will drain more quickly.
For any and all quesPons related to your CamRanger, please email
support@CamRanger.com for prompt responses.
© CamRanger – Patent Pending
25