Camranger Pt Hub And Tripod; Camranger Pt Hub Hardware - CamRanger User Manual

dictates the pracPcal maximum.
If the CamRanger is only connected to the CamRanger network, the CamRanger Share app users
will also need to connect to the CamRanger network, using the same password, however no
registraPon is required. If the CamRanger is bridged to an exisPng Internet network, the Share
app user can connect to the same Internet network that the CamRanger is connected to, and
sPll use the Share app. Those using the share app should consult the CamRanger Controller
about the network connecPon and should stay within range of the CamRanger or bridged
network when using the app
For more informaPon about the CamRanger Share ApplicaPon, refer to the CamRanger Share
App User Guide Video (Note: this video is demonstraPng the setup with an iPad, but the general
concept and use with the Mac is the same).
CamRanger PT Hub and Tripod
• To use the CamRanger PT Hub and Motorized tripod, a
CamRanger is required.
• The CamRanger PT Hub and MP-360 (MP 101, Bescor, or Hague)
will only work with CamRanger firmware 6 and up and the latest
Mac sohware. Refer to www.CamRanger.com/downloads for the
CamRanger firmware update and latest Mac applicaPon.
CamRanger must be registered (see CamRanger user
manual) while the CamRanger PT Hub does not require
registraPon.
CamRanger PT Hub Hardware
• The CamRanger powers the CamRanger PT Hub.
USB 2.0 A-end port (USB
2.0 A to B connector
included with CamRanger
Hub)
© CamRanger – Patent Pending
The
Serial Connector port
(Cable included with
CamRanger PT Hub)
USB port (USB cable
included with the
CamRanger or Camera)
21