Installation; Handling - McQuay AGZXXXBS Series Installation, Operation And Maintenance Manual

Installation

Not
with local codes and regulations.

Handling

Be careful to avoid rough handling of the unit. Do not push or pull the unit from
anything other than the base. Block the pushing vehicle away from the unit to prevent
damage to the sheet metal cabinet and end frame (see Figure 1).
To lift the unit, 2 1/2" (64mm) diameter lifting tabs are provided on the base of the
unit. Arrange spreader bars and cables to prevent damage to the condenser coils or
cabinet (see Figure 2).
Figure 1, Suggested Pushing Arrangement
Figure 2, Suggested Lifting Arrangement
Spreader bars Spreader bars
(use caution) (use caution)
4
e: Installation is to be performed by qualified personnel who are familiar
Sharp edges on unit and coil surfaces are a potential hazard to personal safety.
required required
AGZ 026B through 130B
WARNING
Avoid contact with them.
Blocking is required
across full width
Number of fans may vary
from this diagram. The lifting
method will remain the same.
All rigging locations
must be used.
IOMM AGZ-5