Attaching The Bracket Onto The Din Rail - Cisco IR1101 Hardware Installation Manual

2. Attach the DIN mounting bracket (1) to the router using the two screws provided in the kit (2). Position the bracket
over the two mounting holes (3) that correspond to your orientation. Then use 13-15 in. lbs. of torque to screw the
bracket onto the router.
3. Once the bracket is attached to the router, it can be mounted onto the DIN Rail.

Attaching the Bracket onto the DIN Rail

To attach the Cisco IR101 with the bracket to a DIN rail, follow these steps. Refer to
Figure 6 Attaching the Bracket to the DIN Rail
1. Position the router so that the lower edge and spring of the Din clip (1) engages with the bottom section of the Din
rail (2).
2. Push up on the router so that the spring of DIN clip (1) compresses against the lower section of DIN rail (2) and then
rotate the router so that the top hook of the DIN clip (1) clamps to the top section of DIN rail (2).
3. To remove the router from the DIN Rail, simply reverse the procedure.
NOTE: The procedure to attach the unit to the rail is the same with both orientations.
NOTE: In order to prevent excessive side to side movement of the unit it is advised to install DIN rail stop plates such
as Mouser part Numbers 653-PFP-M, 651-1201662 or 845-CA402. These stop plates can be installed on one or
both sides of the unit to limit excessive side to side movement that typically occurs in high vibration environments.
32
Figure 6 for details.