Installing A Din Rail - Cisco 809 Hardware Installation Manual

Industrial integrated services router

Hide thumbs Also See for 809:

Table of Contents

Installing the Router

Step 2

Install the router to a wall stud using two number-10 wood screws, round- or pan-head, with number-10 washers or two

number-10 washer-head screws. The screws must be long enough to penetrate at least 1.0 inch (25.4 mm) into the

supporting wood or metal wall stud.

Note

For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and washers

must be size number 10.

Step 3

Route the cables so that they do not put a strain on the connectors or mounting hardware. To comply with IP 40, cables

should be routed down relative to the router to prevent water from traveling on the cables.

Installing a DIN Rail

The DIN Rail can be installed in two different orientations. With the cable side of the device facing up or

down. The DIN Rail bracket can be mounted on the front or the back of the router.

Note

The IR809 meets IP30 rating when mounted vertically.

To attach the Cisco IR809 to a DIN rail, follow these steps:

Cisco 809 Industrial Integrated Services Router Hardware Installation Guide

Table of Contents

Ir809g-lte-la-k9