Allen-Bradley PowerFlex 700H Service Manual page 64

3-26 Access Procedures
Fan Inverter Locations
Remove cable-ties
5. Remove the cable-ties that secure the cables with black insulation to the
fan inverter assemblies. This will allow you to move the cables and
remove the inverter assemblies.
6. Disconnect the fan motor cable under the inverter.
7. Remove the four M5 POZIDRIV screws, which secure the bottom of
the fan inverter to the drive. Proper tightening torque for reassembly is 4
N-m (35 lb.-in.).
8. Disconnect the cables at X2, X8 and X3 (on left-hand and center
inverters); and X2 and X8 (on right-hand inverter).