Table of Contents
Advertisement
Troubleshooting Your 600i2 Interactive Whiteboard System
In this Chapter
This chapter deals with basic troubleshooting issues for your SMART Board 600i2 interactive whiteboard system
that you can easily solve. For more complex issues or issues not mentioned in this section, please contact your
authorized SMART reseller
•
System Warning Lights
–
Extended Control Panel (ECP) Ready Light and System Status
–
Projector Ready Lights and Projector Status
–
Interactive Whiteboard Ready Light
System Warning Lights
Extended Control Panel (ECP) Ready Light and System Status
The ECP ready light is located on the ECP's main power button. This button also functions as your status
warning light.
Ready light
off
solid amber
flashing green
solid green
flashing amber
Projector Ready Lights and Projector Status
The three projector ready lights are located on the underside of the projector. They are marked Lamp,
On/Standby and Temp (for temperature).
Lamp
status light
off
off
off
99-00850-21 A0
and consult the
SMART technical support
Status
The projector system is not receiving power. Check your power cord and
power supply. If nothing changes after checking your power cord and power
supply, call your
The projector is receiving power, but it is turned off.
The projector is receiving power and is starting up.
The interactive whiteboard system is on.
The interactive whiteboard system is about to enter Standby mode.
On/Standby
Temp
status light
status light
off
off
solid green
off
solid red
flashing red
Troubleshooting Your 600i2 Interactive Whiteboard System
website.
authorized SMART reseller
Projector Status
The projector isn't receiving power. Check the
connection and the power supply.
The projector is operating normally.
The projector is overheating. Make sure nothing is
blocking the airflow into or away from the internal
fans. Turn off, unplug and reconnect the power cord,
wait a few minutes and then turn on the system.
to solve the problem.
31
Advertisement
Table of Contents
