Configuring Network Connection; Figure 5-2 Ip-Ak2 Web Server Direct Connection; Figure 5-3 Local Area Connection Properties - Honeywell IP-AK2 Installation And Configuration Manual

Configuring via IP-AK2 Web Server

Figure 5-2 IP-AK2 Web Server Direct Connection

Configuring Network Connection

1.
2.

Figure 5-3 Local Area Connection Properties

3.
4.
16
Ethernet
Crossover
Cable
The IP-AK2 panel connected is the Master panel. DIP switch 6 on a Master panel
Note
must be set to "ON".
On the computer Desktop, click Start
Identify your local Ethernet connection (commonly labeled Local Area Connection),
and right click the icon, the Local Area Connection Properties page will display.
Highlight the "Internet Protocol (TCP/IP)" connection, and click【Properties】to
display your system's current Internet Protocol properties.
Note Keep a record of your computer's current network configuration for future use.
Select【Use the following IP address】and configure the parameters as below:
IP-AK2
Connect the computer's Ethernet
port directly to the IP-AK2 panel's
Ethernet port with an Ethernet
cable.
Control Panel Network Connections.