Figure 5-30 Input Settings Page; Figure 5-31 Door Status 1; Figure 5-32 Door Status 2; Figure 5-33 Door Status 3 - Honeywell IP-AK2 Installation And Configuration Manual

Configuring via IP-AK2 Web Server
•
•

Figure 5-30 Input Settings Page

There are four possible mode configurations. The figure above shows the normally
Closed/Unsupervised mode. The following figures show the remaining modes.

Figure 5-31 Door Status 1

Figure 5-32 Door Status 2

Figure 5-33 Door Status 3

On Input Settings page, you can:
•
•
30
o Cut (supervised input only): indicates that the electrical circuit on the door has
been cut or disconnected.
Egress
Tamper - Indicates abnormal handling of the reader device.
Define the Status, Egress and Tamper inputs' access mode.
Specify the Status, Egress and Tamper shunt time, or the period of time when the
normal state will be ignored.