Table A-1 Default Reader Ports
Reader Number
1
2
Reader Tamper Inputs
The card readers have a Tamper signal wired to the IP-AK2 panel. This is a two-state
input configured as a Normally Closed contact.
The followings are the default Reader Tamper Inputs to Panel Input associations:
Table A-2 Default Reader Tamper Inputs
Tamper LED
Tamper 1
Tamper 2
Door Egress Inputs
The panel has a Request-To-Exit (Egress) input for each door. The default condition is a
two-state input configured as Normally Closed contact. When the egress input is active,
the associated output relay will be active.
The followings are the default egress input associations:
Table A-3 Default Door Egress Inputs
Egress input
1
2
Door Status Inputs
The panel has a Door Status input for each door. The default condition is a two-state
input configured as a Normally Closed contact.
The following are the default door status input associations:
Table A-4 Default Door Status Inputs
Door Status input
1
2
Controls...
Relay 1 (Output 1)
Relay 2 (Output 2)
Reports as...
Input 7
Input 8
Controls relay...
Panel input
1
SUP1
2
SUP3
Panel input
SUP2
SUP4
Honeywell
Reports as...
Input 1
Input 3
Reports as...
Input 2
Input 4
53