Grizzly G0782 Owner's Manual page 66

13" x 40" gearhead floor lathe
Table of Contents

Advertisement

Adding Oil
The oil fill plug is located on top of the headstock,
as shown in Figure 109.
Headstock
Fill Plug
Figure 109. Location of headstock fill plug.
To change headstock oil:
1.
DISCONNECT MACHINE FROM POWER!
2.
Open end gear cover.
3.
Remove V-belts so that oil does not get on
them, which may necessitate their replace-
ment (refer to Replacing V-Belts on Page 79
for detailed instructions).
4.
Remove fill plug from top of headstock.
5.
Place 2-gallon catch pan under headstock
drain plug (see Figure 110), then remove
drain plug with 8mm hex wrench.
Figure 110. Location of headstock drain plug.
-64-
6.
7.
8.
Quick-Change Gearbox
Oil Type .... Grizzly T23962 or ISO 68 Equivalent
Oil Amount .......................................... 2.1 Quarts
Check/Add Frequency ................................. Daily
Change .................. Every 1000 Operating Hours
Checking Oil Level
The gearbox reservoir has the proper amount of
oil when the oil level in the sight glass is approxi-
mately halfway. The oil sight glass is located
below the end gears, as shown in Figure 111.
Headstock
Drain Plug
Changing Oil
Change the quick-change gearbox oil after the
first 300 hours of use, then after every 1000 hours
of use. Place a catch pan under the quick-change
gearbox drain plug (see Figure 111). Use a 8mm
hex wrench to remove the gearbox fill plug (see
Figure 111), then remove the drain plug and
allow the gearbox reservoir to empty. Re-install
the drain plug and add oil until the level is approxi-
mately halfway in the gearbox oil sight glass, then
re-install the fill plug.
When headstock reservoir is empty, replace
drain plug and clean away any spilled oil.
Fill headstock reservoir until oil level is
approximately halfway in sight glass.
Replace and re-tension the V-belts (refer to
Replacing V-Belts on Page 79), then close
end gear cover before re-connecting lathe to
power.
Fill Plug
Drain
Plug
Figure 111. Location of gearbox fill and drain
plugs and oil sight glass.
Model G0782 (Mfd. Since 10/15)
Gearbox Oil
Sight Glass

Advertisement

Table of Contents
loading

Table of Contents