Sony UP-D6500 Operating Instructions Manual page 29

4
While pulling the print head up slightly, rotate it in
the direction shown in the figure.
5
Remove the two connectors at the rear of the print
head.
6
Connect the connectors on the new print head in
place of those removed in step 5.
7
Roll the print head in the direction shown in the
figure so the holes in the print head align with the
hooks in the head holder.
8
Put the hooks in the head holder into the holes in
the print head, and move the print head back until
it locks.
9
Remove the protective cover sheet from the head.
29
Appendixes