Advantech MIO-5850 User Manual page 11

* HDMI/DisplayPort: HDMI 1.4a with audio, up to 1080P at 60Hz.
* LVDS: 48-bit dual channel LVDS up to WUXGA 1920x1200 at 60Hz
CH7511.
* Inverter power: 1A @ 5V/12V
– 3D HW acceleration: OGL4.0, DirectX 11.1
– HW video decode: H.264, MPEG2, VC-1, VP8
– HW video encode: H.264, MPEG2 (max at 1080p)

Gigabit Ethernet
®
– Controller: Intel
* 10/100/1000 BASE-T
* IEEE 802.3az Energy Efficient Ethernet (EEE), which defines Low Power Idle (LPI) state
* IEEE 1588/802.1AS precision time synchronization
* 9.5 KB jumbo frames supported (full-duplex)
* Flow control supported
* Magic packet wake-up enable with unique MAC address

Peripheral interface
– 1 Serial-ATA port, up to 3.0Gb/s transfer rate (300 MB/s), supports indepen-
dent DMA operation
* SATA power: 5V / 12V
– 1 x USB 3.0 & 5 x USB2.0
* One USB 3.0 and 1 USB 2.0 on rear I/O, 4 x internal USB2.0
* USB 3.0 SuperSpeed (SS), implements xHCI software host controller interface
* Multiplexed with EHCI controller that are High-Speed/Full-Speed (HS/FS)
* USB source: USB 3.0 and USB 2.0's dual port on rear I/O's USB signal directly
from CPU, 4 x USB 2.0 from USB hub.
* Supports wake-up from sleeping state S3
* Power supply: 0.5A @ 5V for USB2.0, 1A @ 5V for USB3.0
– 2 RS232/422/485 for COM1/2, 2 RS232 for COM3/4 (ESD protection: air gap
±15kV, contact ±8kV
– 8-bit programmable general purpose input/ output from iManager (5V tolerance)
2
– 1 SMBus / I C channel from iManager
– Watchdog timer: Output system reset, programmable counter from 1 ~ 255
minutes/ seconds
– Mini PCIe / mSATA
 1 Full-size Mini PCIe with SIM holder (with PCIe and USB interface)
 1 Half size mSATA (with SATA and USB interface)
 Power supply: 1.1 A @ 3.3 V, 0.375 A @ 1.5 V
– M.2 E Key

High Definition Audio:
®
– Intel High Definition Audio Interface
– High definition audio codec with Realtek proprietary loss-less content protec-
tion technology
– Supports 1 Line-input, 1 Line output, 1 Mic-input

BIOS
– AMI UEFI 64 Mbit, BIOS for 64 or 32-bit is different, default version is for 6-bit
– Default setting is legacy boot, that can be manually changed to UEFI boot. If
default setting to UEFI is needed, that can be done by T-P/N
–
i210
3
via
MIO-5850 User Manual