Siruba 700L Original Instructions Manual page 22

2. 潤滑油之更換 ( 圖 13)
(1) 將螺絲Ⓑ放鬆旋開，使油槽內的油完全排出
後再將螺絲Ⓑ鎖緊。
(2) 為延長本機器之壽命，請於開始使用後四個
星期更換新油，爾後約每四個月更換一次。
(3) 為延長本機器之壽命，特別裝有濾油器之機
構，請在每使用一個月後卸下清洗乾淨，必
要時得換新品。
3. 針之冷卻油
使用油 : 矽油 (SILICON OIL)。( 圖 14)
P18
2.Drainage and refill the oil :(Fig. 13 )
(1)Loosen the screw Ⓑ and drain all the oil
inside the oil tank. Then, tighten the screw
Ⓑ again.
(2)In order to extend the term of usage, please
replace the oil after the first four week, and
then replace it every four months.
(3)To extend the usage term, this machine has
equipped an oil filter. Please disassemble
and clean it every month, as well as change
it if needed.
3. Needle cooling lubrication oil:
SILICON OIL. (Fig. 14 )
圖 13 / Fig. 13
圖 14 / Fig. 14