Name Your Device; Set Up A Network Connection With 802.1X Authentication; Enable Wifi - Polycom EagleEye Director II Administrator's Manual

Procedure
1. Select the drop down arrow with the language label, then select your language from the list.
Note: This button is located at the top right of all screens, and on the Welcome screen when you
first log in.

Name Your Device

Name your EagleEye Director II camera to distinguish the device from other cameras or other devices in
a connection list.
Procedure
1. In the web interface, go to General Settings > Device Name.
2. Enter a descriptive name for your device. For instance, name it using the location or owner's
name.
3. Select Save.
Set Up a Network Connection with 802.1x
Authentication
If you need the EagleEye Director II camera to access a network that requires 802.1x authentication, you
must configure settings in the camera web interface.
Prerequisites
▪ Discover the EagleEye Director II camera IP address using the EagleEye Director II App.
▪ Use an Ethernet cable to connect the camera to your local computer.
Procedure
1. In the camera's web interface, select Network Settings > Ethernet.
2. At 802.1x, select Enable.
3. At Identity, enter a name that identifies this setting.
4. At Password, enter a password.
5. Go to General Settings > Device Name.
6. If you have not entered a device name, do it now.
7. Log out of the web interface.

Enable WiFi

To cascade two cameras using a direct Ethernet cable connection, enable WiFi for web interface access.
Polycom, Inc.
Setting Up Connections
15