Setting Up Connections; Connect To The Camera Web Interface; Change Your Language - Polycom EagleEye Director II Administrator's Manual

Setting Up Connections

Topics:
▪

Connect to the Camera Web Interface

▪

Change Your Language

▪ Name Your Device
▪ Set Up a Network Connection with 802.1x Authentication
▪ Enable WiFi
▪ Configure a Connection Mode
To customize settings for the EagleEye Director II camera, such as white balance, color saturation levels,
or camera tracking, you can connect to the camera's web interface. You can also configure camera and
tracking settings in the web interface of the RealPresence Group Series system. The last changes to the
settings, no matter which web interface is used, are applied.
Connect to the Camera Web Interface
To connect to the web interface for the EagleEye Director II camera for the first time, you must complete a
few configuration steps.
Prerequisites
▪ Discover the camera IP address using the EagleEye Director II App.
▪ To cascade two cameras using a direct Ethernet cable connection, WiFi must be enabled for web
interface access.
Procedure
1. Power on the EagleEye Director II camera.
2. In a web browser, enter the camera's IP address that you discovered using the EagleEye Director
II App.
3. Enter the username admin with the default password (last six digits of the camera's serial
number).
Polycom recommends that you change your password from the default for security reasons.
4. Select Login.
If this is the first time you have accessed the web interface, you must select a region.
Change Your Language
You can change the language displayed in the EagleEye Director II camera web interface.
Polycom, Inc. 14