Bottom Cover Removal Warning
When removing the bottom cover and screws for the purposes of changing battery, remember to put
back the cover and screws before power on the POS.
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
Warning for internal battery pack
To reduce risk of fire or burns:
1.
Do not attempt to open, disassemble, or service the battery pack.
2.
Do not crush, puncture, short external contacts, or dispose of in fire or water.
3.
Do not heat above 60
9. I
SAM
NSERT
After removing the battery, the user can find SAM *2 (left) slots at the bottom side of device.
Please insert the card correctly as the icon shown on the cover:
10. L
T
OADING
Gently pop the printer cover's latch; then pull the cover (Figure 11). Load a roll of thermal
paper into the printer. Load it so that the print‐side of the paper will feed out facing the
operator. Close the cover by pressing on the center of the printer cover. Use the serrated bar
to tear off any excess paper.
Figure 8 Figure 9
o
C
CARD
P
HE
APER
Figure 10