Regulatory Information; Fcc - United States; Industry Canada; Europe - GDD Instrumentation MPP3wifi Instruction Manual

Magnetic susceptibililty, conductivity meter

Table of Contents

 Regulatory Information

17.1 FCC – United States

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two (2)

conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy, and if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to the MPP3wifi that are not expressly approved by Instrumentation GDD

inc. could void the user's authority to operate the equipment.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the

following two (2) conditions :

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired

operation of the device.

This device contains a transmitter module that conforms to the emission standard EN 300 328 V1.7.1.

Instrumentation GDD inc.

2017-08-21

Table of Contents