Getting Started; Initial Inspection; Checking Power Meter Firmware And Dsp Revision - Keysight Technologies E Series Operating And Service Manual

1 Introduction

Getting Started

Initial inspection

Inspect the shipping container for damage. If the shipping container or packaging
material is damaged, it should be kept until the contents of the shipment have
been checked mechanically and electrically. If there is mechanical damage, notify
the nearest Keysight Technologies office. Keep the damaged shipping materials (if
any) for inspection by the carrier and a Keysight Technologies representative. If
required, you can refer to the

Checking power meter firmware and DSP revision

Before proceeding, first ensure your Keysight EPM series power meter has the
required firmware and DSP revisions (E4418B and E4419B only) for the correct
operation of your Keysight EPM series power meters.
On the power meter press
Figure 1-3
24
"Sales and Technical Support"
,
Power meter firmware version screen
Keysight E-Series E9300 Operating and Service Guide
Service Version
, ,
Firmware
Revision Code
(dual channel)
DSP Revision
Code
on page 10
.