Defaults For Asa Firepower - Cisco ASA Series Configuration Manual

Defaults for ASA FirePOWER

ASA Clustering Guidelines
Does not support clustering directly, but you can use these modules in a cluster. You are responsible for
maintaining consistent policies on the ASA FirePOWER modules in the cluster using FireSIGHT
Management Center.
Model Guidelines
•
•
ASDM Guidelines for Managing ASA FirePOWER (Supported Models)
•
•
•
Additional Guidelines and Limitations
•
•
•
Defaults for ASA FirePOWER
The following table lists the default settings for the ASA FirePOWER module.
Table 7-1
Parameters
Management IP address
Gateway
SSH or session Username
Password
Cisco ASA Series Firewall CLI Configuration Guide
7-6
For ASA model software and hardware compatibility with the ASA FirePOWER module, see
ASA Compatibility.
For the 5512-X through ASA 5555-X, you must install a Cisco solid state drive (SSD). For more
information, see the ASA 5500-X hardware guide. (The SSD is standard on the 5506-X, 5508-X,
and 5516-X.)
If you enable command authorization on the ASA that hosts the module, you must log in with a user
name that has privilege level 15 to see the ASA FirePOWER home, configuration, and monitoring
pages. Read-only or monitor-only access to ASA FirePOWER pages other than the status page is
not supported.
If you are using Java 7 update 51 up to Java 8, you need to configure identity certificates for both
the ASA and the ASA FirePOWER module. See
You can never use both ASDM and FireSIGHT Management Center, you must choose one or the
other.
See Compatibility with ASA Features, page
You cannot change the software type installed on the hardware module; if you purchase an ASA
FirePOWER module, you cannot later install other software on it.
You cannot configure both normal inline mode and inline tap monitor-only mode at the same time
on the ASA. Only one type of security policy is allowed. In multiple context mode, you cannot
configure inline tap monitor-only mode for some contexts, and regular inline mode for others.
ASA FirePOWER Default Network Parameters
Default
admin
Install an Identity Certificate for
7-5.
• System software image: 192.168.45.45/24
• Boot image: 192.168.8.8/24
System software image: none
•
Boot image: 192.168.8.1/24
•
System software image: Sourcefire
•
Boot image: Admin123
•
Chapter 7 ASA FirePOWER Module
Cisco
ASDM.