Access The Asa Firepower Cli; Configure Asa Firepower Basic Settings - Cisco ASA Series Configuration Manual

Chapter 7 ASA FirePOWER Module

Access the ASA FirePOWER CLI

To access the ASA FirePOWER CLI, you can use one of the following methods.
Console Port
•
•
SSH
You can connect to the module default IP address (see
can use the following ASA command to change the management IP address, and then connect using
SSH:
session {1 | sfr} do setup host ip ip_address/mask,gateway_ip
Use 1 for a hardware module, sfr for a software module.

Configure ASA FirePOWER Basic Settings

The first time you access the ASA FirePOWER module CLI, you are prompted for basic configuration
parameters. You must also add the module to the FireSIGHT Management Center (optional for the ASA
5506-X/5508-X/5516-X).
Procedure
At the ASA FirePOWER CLI, log in with the username admin and the password Sourcefire.
Step 1
Complete the system configuration as prompted.
Step 2
Use the following network settings for the ASA FirePOWER module for the recommended network
deployment
•
•
•
Step 3 (Optional for 5506-X/5508-X/5516-X) Register the ASA FirePOWER module to a FireSIGHT
Management Center:
> configure manager add {hostname | IPv4_address | IPv6_address | DONTRESOLVE} reg_key
[nat_id]
where:
ASA 5585-X—This model includes a dedicated console port for the ASA FirePOWER module. Use
the supplied DB-9 to RJ-45 serial cable and/or your own USB serial adapter.
All other models—Connect to the ASA console port using the supplied DB-9 to RJ-45 serial cable
and/or your own USB serial adapter. The ASA 5506-X/5508-X/5516-X also has a mini-USB console
port. See the hardware guide
At the ASA CLI, session to the ASA FirePOWER module:
session sfr
See also Session to the Software Module From the ASA, page
(Deploy the ASA FirePOWER Module in Your Network, page
Management interface: 192.168.1.2
Management subnet mask: 255.255.255.0
Gateway IP: 192.168.1.1
for instructions on using the USB console port.
Defaults for ASA FirePOWER, page
Cisco ASA Series Firewall CLI Configuration Guide
Perform Initial ASA FirePOWER Setup
7-20.
7-6) or you
7-7):
7-9