Configure Dns Inspection Policy Map - Cisco ASA Series Configuration Manual

Chapter 13 Inspection of Basic Internet Protocols
Procedure
Step 1 Configure DNS Inspection Policy Map, page
Step 2 Configure the DNS Inspection Service Policy, page

Configure DNS Inspection Policy Map

You can create a DNS inspection policy map to customize DNS inspection actions if the default
inspection behavior is not sufficient for your network.
When defining traffic matching criteria, you can either create a class map or include the match
statements directly in the policy map. The following procedure explains both approaches.
Before You Begin
Some traffic matching options use regular expressions for matching purposes. If you intend to use one
of those techniques, first create the regular expression or regular expression class map.
Procedure
(Optional) Create a DNS inspection class map by performing the following steps.
Step 1
A class map groups multiple traffic matches.You can alternatively identify match commands directly in
the policy map. The difference between creating a class map and defining the traffic match directly in
the inspection policy map is that the class map lets you create more complex match criteria, and you can
reuse class maps.
To specify traffic that should not match the class map, use the match not command. For example, if the
match not command specifies the string "example.com," then any traffic that includes "example.com"
does not match the class map.
For the traffic that you identify in this class map, you specify actions to take on the traffic in the
inspection policy map.
If you want to perform different actions for each match command, you should identify the traffic directly
in the policy map.
a.
b.
c.
Create the class map by entering the following command:
hostname(config)# class-map type inspect dns [match-all | match-any] class_map_name
hostname(config-cmap)#
Where the class_map_name is the name of the class map. The match-all keyword is the default, and
specifies that traffic must match all criteria to match the class map. The match-any keyword
specifies that the traffic matches the class map if it matches at least one match statement. The CLI
enters class-map configuration mode, where you can enter one or more match commands.
(Optional) To add a description to the class map, enter the following command:
hostname(config-cmap)# description string
Where string is the description of the class map (up to 200 characters).
Specify the traffic on which you want to perform actions using one of the following match
commands. If you use a match not command, then any traffic that does not match the criterion in
the match not command has the action applied.
13-3.
13-6.
Cisco ASA Series Firewall CLI Configuration Guide
DNS Inspection
13-3