Cisco ASA Series Configuration Manual page 268

Configure Application Layer Protocol Inspection
Table 12-2
Keywords
icmp error
ils
im [map_name]
ip-options [map_name]
ipsec-pass-thru [map_name]
ipv6 [map_name]
mgcp [map_name]
netbios [map_name]
pptp
radius-accounting map_name
rsh
rtsp [map_name]
Cisco ASA Series Firewall CLI Configuration Guide
12-12
Protocol Keywords
Chapter 12 Getting Started with Application Layer Protocol Inspection
Notes
See ICMP Error Inspection, page
See ILS Inspection, page 15-12.
See Instant Messaging Inspection, page
If you added an Instant Messaging inspection policy map
according to Configure an Instant Messaging Inspection
Policy Map, page 13-22, identify the map name in this
command.
See IP Options Inspection, page
If you added an IP Options inspection policy map according
to Configure an IP Options Inspection Policy Map,
page 13-28, identify the map name in this command.
See IPsec Pass Through Inspection, page
If you added an IPsec Pass Through inspection policy map
according to Configure an IPsec Pass Through Inspection
Policy Map, page 13-31, identify the map name in this
command.
See IPv6 Inspection, page
If you added an IPv6 inspection policy map according to
Configure an IPv6 Inspection Policy Map, page
identify the map name in this command.
See MGCP Inspection, page
If you added an MGCP inspection policy map according to
Configuring an MGCP Inspection Policy Map for
Additional Inspection Control, page
name in this command.
See NetBIOS Inspection, page
If you added a NetBIOS inspection policy map according to
Configure a NetBIOS Inspection Policy Map for Additional
Inspection Control, page 13-37, identify the map name in
this command.
See PPTP Inspection, page
See RADIUS Accounting Inspection, page
The radius-accounting keyword is only available for a
management class map. You must specify a RADIUS
accounting inspection policy map; see
Accounting Inspection Policy Map, page
See RSH Inspection, page
See RTSP Inspection, page
If you added a RTSP inspection policy map according to
Configure RTSP Inspection Policy Map, page
identify the map name in this command.
13-21.
13-21.
13-26.
13-30.
13-33.
13-34,
14-12.
14-14, identify the map
13-37.
13-39.
15-13.
Configure a RADIUS
15-14.
15-16.
14-17.
14-19,