Table of Contents
Advertisement
3E2374 Sheep Auto Drafter User Manual
Green power LED flashing
The power supply is low.
Although the Sheep Auto Drafter can continue to operate it may be worthwhile
checking your power supply.
White mode LED flashing
Single flash
The Sheep Auto Drafter is in standby and ready to operate.
Press the Start
continue or press the Entry Gate button on the Control Bridge for 2 seconds or
more.
Double flash
The Sheep Auto Drafter has been stopped using the Entry Gate button on the
Control Bridge.
Press the Entry Gate button on the Control Bridge to resume operation.
Red E-Stop LED flashing
The E-Stop button is depressed.
Release it and then press either the Start
remote control to continue or press the Entry Gate button on the Control Bridge
for 2 seconds or more.
Remote control won't work or the auto sorting unit is not responding to the
remote control
Are the batteries flat?
•
Try changing them.
Is the remote control damaged?
•
Was the Entry Gate button on the Control Bridge pressed to release an
•
animal? This button must be pressed again to resume operation.
There is a short in a solenoid or the cabling
The unit will not operate. Contact your Gallagher representative for advice on
how to repair this issue.
No drafting decision made
Has the scale indicator been set up correctly for drafting?
•
Have either "drafting by weight" or "drafting by list" instructions been set up
•
in your scale indicator?
Is the RS232 cable securely attached between the scale indicator and the
•
Sheep Auto Drafter?
Is the RS232 cable attached to the correct port on the scale indicator?
•
Multiple sheep in Sheep Auto Drafter
See To clear multiple animals from the unit (p 36) for instructions on how to deal
with this.
or Retain/Release
button on the remote control to
or Retain/Release
button on the
Page 45
Advertisement
Table of Contents
