Table of Contents
Advertisement
3E2374 Sheep Auto Drafter User Manual
PURPOSE AND FUNCTION OF CONTROL
BRIDGE LAMPS (LEDS) AND BUTTONS
Lamps
The Control Bridge houses a number of different lamps, both on top and around
the front (above the entry gate) (see Figure 14). These are intended to give you
an indication of the Sheep Auto Drafter's operational status, (i.e. if it is ready to
operate, operating normally or has a fault).
Figure 14. Position of Sheep Auto Drafter Control Bridge lamps and buttons
Table 2 describes the purpose of each lamp. Refer to the Troubleshooting (p 42)
section for the specifics of how LEDs indicate particular problems.
LED
colour
Green
(power)
White
(mode)
LED
LED state
position
Off
Sheep Auto
Beside
•
Drafter
power
switched off
button on
Control
No power
•
Bridge
supply
Too much
•
power
Sheep Auto
•
Wrapped
Drafter
around
Flashing
Power supply low
Single flash
Sheep Auto
•
On
Sheep Auto Drafter
switched on
Sheep Auto Drafter
is in Automatic
Page 25
Advertisement
Table of Contents
