Table of Contents
Advertisement
To turn the Sheep Auto Drafter on if the E-Stop button is depressed
The procedure to turn the Sheep Auto Drafter on is slightly different if the E-stop
button is depressed, however it is not expected that this will be a regular
occurrence.
1.
Press the Power button, which is situated on the Control Bridge (see Figure
16). The green power light should come on (if it doesn't refer to
Troubleshooting (p 42) for ideas on how to resolve the problem). The white
LED mode lamp will now start flashing to indicate that the unit is ready to
communicate with the remote control.
2.
If the E-Stop button is depressed the red E-Stop LED will start flashing. You
need to release the E-Stop button before you can continue with the start up.
Once it is released the E-Stop lamp will switch off.
3.
Restart the Sheep Auto Drafter by either;
Using the Remote
Press the green Start button
with the Sheep Auto Drafter. The unit will start to operate in Automatic
Release Mode.
Or
From the Control Bridge
Press the Entry Gate button to resume operations.
For more about this and how to use the Auto Drafter see Using the Sheep Auto
Drafter (p 32).
For more about the use of the E-Stop button see Using the E-Stop button to halt
Sheep Auto Drafter operation (p 37).
Adjusting the Sheep Auto Drafter width
Both of the Sheep Auto Drafter side panels can be adjusted to a variety of
positions by using the four slots provided on either side. Adjusting them at the
bottom of the panel will allow you to resize the unit for different sized animals
(so that they are restricted from turning around) and adjusting them at the top
will allow more room for handler access to stock. These slots will allow you to
resize the unit from 300-525mm wide.
Page 30
3E2374 Sheep Auto Drafter User Manual
on the remote control to synchronise it
Advertisement
Table of Contents
