Table of Contents
Advertisement
To clear multiple animals from the Sheep Auto Drafter
Occasionally multiple animals may enter the unit at the same time. In this
scenario you will want to remove the extra animal(s).
1.
Press the Entry Gate button on the remote control
Gate button on the Control Bridge.
• This will open the entry gate.
• The white LED mode lamp will begin to flash.
2.
Remove the extra animal(s).
3.
Press the Start
close the gate and restart the unit operation or press the Entry Gate button
on the Control Bridge.
• Pressing Start on the remote or the Entry Gate button on the Control
• Pressing Retain/Release will put it into Manual Release Mode.
If the issue occurs during a weighing session there are two possible additional
factors to consider:
a)
Have you pressed the Entry Gate button before the scales have locked in a
weight?
b)
Have you pressed the Entry Gate button after the scales have locked in a
weight?
If option a) occurs then you don't need to take any further action. However, if
option b) occurs it is a good idea to remove the false weight reading from the
scale indicator before you continue (to find out how to do this refer to your scale
user manual).
Using the Stop button to pause Sheep Auto Drafter
operation
Occasionally you may want to briefly stop the Sheep Auto Drafter so that you can
carry out another task, (e.g. answer a phone call or shift some sheep which are
out of range of the Sheep Auto Drafter).
To stop the Sheep Auto Drafter
1.
Press the red Stop button
• The entry gate will close and the exit gate will open.
• The white LED mode lamp will begin to flash.
Note: If you were operating in Automatic Release Mode any operation the
unit was carrying out will be completed before an animal is released, (e.g. if
Page 36
or Retain/Release
Bridge will put the unit into Automatic Release Mode.
3E2374 Sheep Auto Drafter User Manual
button on the remote control to
on the remote control.
or press the Entry
Advertisement
Table of Contents
