Product Specific Information; Appliance Certification; Glass Specifications; Btu Specifications - Heat & Glo SL-3X Owner's Manual

2

Product Specific Information

A. Appliance Certification
MODELS: SL-3X, SL-5X, SL-5XLP, SL-7X,
SL-7XLP SL-9X
LABORATORY: Underwriters Laboratories, Inc. (UL)
TYPE: Direct Vent Heater
STANDARD: ANSI Z21.88-2014 • CSA 2.33-2014
This product is listed to ANSI standards for "Vented Gas
Fireplace Heaters" and applicable sections of "Gas Burn-
ing Heating Appliances for Manufactured Homes and
Recreational Vehicles", and "Gas Fired Appliances for
Use at High Altitudes".
NOTICE: This installation must conform with local codes.
In the absence of local codes you must comply with the
National Fuel Gas Code, ANSI Z223.1-latest edition in
the U.S.A. and the CAN/CGA B149 Installation Codes in
Canada.
NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.
This appliance is tested and approved as either supplemen-
tal room heat or as a decorative appliance. It should not be
factored as primary heat in residential heating calculations.
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
6
Heat & Glo • SL-3X, SL-5X, SL-7X, SL-9X Owner's Manual • 2372-981 Rev. F • 7/17
B. Glass Specifications
This appliance is equipped with 5 mm ceramic glass. Re-
place glass only with 5 mm ceramic glass. Please contact
your dealer for replacement glass.
C. BTU Specifications
Models
(U.S. or Canada)
SL-3X (NG)
(0-2000 FT)
SL-3X (LP)
(0-2000 FT)
SL-5X (NG)
(0-2000 FT)
SL-5X (LP)
(0-2000 FT)
SL-7X (NG)
(0-2000 FT)
SL-7X (LP)
(0-2000 FT)
SL-9X (NG)
(0-2000 FT)
SL-9X (LP)
(0-2000 FT)
Minimum Orifice
Maximum
Input Size
Input BTU/h
BTU/h (DMS)
21,000 11,500 #44
18,000 9,500 #55
27,500 14,500 #40
25,000 13,000 #53
30,500 17,500 #37
29,500 18,000 #52
35,000 18,000 #34
31,000 16,500 #51