Service Parts; Rc300 Quick Reference Guide - Heat & Glo SL-3X Owner's Manual

C. RC300 Quick Reference Guide
IntelliFire Plus™ Multifunction Remote Control
NOTE: For additional information, refer to the RC300
Installation and Operating Instructions or visit www. replaces.
com/rc300demo to view the RC300 demo video.
Display Screen
FIREPLACE STATUS
THERMOSTAT
FLAME HEIGHT
FAN SPEED
ADJUSTABLE
AUXILIARY
ADJUSTABLE
OUTPUT (ON/OFF)
CONSTANT PILOT
TIMER DISPLAY/FUNCTION
Figure 1. RC300 Display Screen
Function Buttons
Use POWER button to turn the unit on and off.
Use MENU button to display the menu functions.
Menu
Only functions that can
displayed. For example: Flame Height will not
be displayed when the remote status is OFF.
Use the SELECT button to select the current
Select
feature.
Use the UP and DOWN arrows to toggle
through the menu functions and value selec-
V
tions in the submenus.
Idle When Remote is in ON Mode
The remote control will go into an idle mode if no but-
tons are pressed within 5 seconds. Press any button to
resume full functionality. In idle mode only active func-
tions will show on the screen.
Hearth & Home Technologies • RC300 Multifunction Remote Control Operating Instructions • 2166-396 Rev. D • 5/15
Operating Instructions - Quick Reference Guide
THERMOSTAT DESIRED
TEMP SETTING
CHILD LOCK
INDICATOR
TRANSMISSION
INDICATOR
LOW BATTERY
INDICATOR
FUNCTION LEVEL
INDICATOR
ROOM TEMP
DISPLAY
be activated will be
Heat & Glo • SL-3X, SL-5X, SL-7X, SL-9X Owner's Manual • 2372-981 Rev. F • 7/17
RC300
Standby mode
The remote control will go into a standby mode if no but-
tons are pressed within 5 minutes. Press the POWER
button to reactivate the remote control to ON mode. Ac-
tive functions will be displayed
About ON Mode
• All functions can be accessed when the remote control
is in the ON mode.
• Only active functions will be displayed when the remote
control is in the ON mode. For example: if the fan is the
only function that's active, the fan icon and  ame will be
the only icon shown in the display.
About OFF Mode
Only the following functions can be accessed in the OFF
mode:
• AUX1
• AUX2
• Constant Pilot
Only active functions will be displayed when the remote
control is in the OFF mode.
Turning On the Fireplace
• Press the POWER button to turn the  replace ON. The
 replace will  rst ignite the pilot. Once the pilot  ame is
established the main burner will be lit.
NOTICE: Whenever the  replace is cycled from OFF to
ON, the main burner will light on high for 10 seconds before
returning to the previous user setting.
1
29