Programming - Screen Innovations Solo Pro Installation Instructions Manual

PROGRAMMING

Setting the Drop - Solo Pro is factory preset to have 1"
of drop, the distance between the top of the viewing
area and the cassette. The drop can be changed to
be up to 12" (4" for Short Throw) to adjust the viewing
area vertically for image placement. To adjust the drop,
do the following:
1. Press the down button on the RF remote to send the
screen to its lower limit.
2. Hold the UP and DOWN buttons simultaneously until
the screen jogs once.
3. Use the DOWN and UP buttons to position the
viewing area vertically, up to 12" (4" for Short Throw)
from the bottom of the cassette.
DO NOT set the lower limit (top of viewing) more
than 12" (4" for Short Throw) from the cassette.
Doing so risks damaging the screen material.
RTS / Programming
4. Once the viewing area is positioned, hold the STOP
button until the screen jogs once. This saves the new
lower limit. If this Step is not completed, the screen
will jog once after about 3 minutes, indicating that it
is no longer in program mode, and the motor will
only recall the previous lower limit. No changes will
be saved.
12 RTS / Programming
1" - 12"
Drop - set by factory at 1". Can be
set up to 12" max."
NOTE: Max. drop for Short Throw is 4".
13