Screen Innovations Solo Pro Installation Instructions Manual page 15

RUNNING
Solo Pro with an RS485 motor is very easy to operate.
The upper and lower screen limits are preset from the
factory. The controls (optional or by others) run the
screen up and down to each limit using the RS485
cable supplied with the screen. The screen cannot be
powered solely by the RS485 cable. Make sure that the
low voltage power supply is also connected.
PROGRAMMING
Setting the Drop:
To adjust the viewing area vertically for image
placement other than that preset at the factory, the drop
can be changed to be up to 12" (4" for Short Throw).
NOTE: Changes to factory settings require a special
RS485 Setting Tool available from Screen Innovations
and ordered separately. This is a point-to-point tool and
RS485 LV Motor / Running and Programming
not a network tool. The tool may be used up to 100 ft.
away when used with 18GA. copper control wire.
To adjust the drop, do the following:
1. Connect the 24VDC power supply to the screen.
2. Disconnect the RS485 cable from the system.
3. If the RS485 cable does not have an RJ45 plug
24 RS485 LV Motor / Programming
connected to it, crimp an RJ45 plug onto the
RS485 communication cable or use a terminal
block to RJ45 adapter.
a. RED to 'h'
b. BLK to 'g'
c. GRN to 'a' or 'b'
25