Screen Innovations Solo Pro Installation Instructions Manual page 16

RS485 Setting Tool
a. Ground
b. Ground
c. Not used
d. Not Used
4. Plug the RJ45 into the setting tool.
5. Turn the setting tool on by pressing the ON/OFF
button.
6. Use the UP and DOWN buttons to point to
"Somfy RS485 Node Discovery".
RS485 LV Motor / Programming
e. Not Used
f. Not Used
g. RS485-
h. RS485+
26
7. Press OK to enter the selection.
8. Once the node ID appears on the screen, press
OK again.
9. Use the directional buttons to navigate to "Down
Limit Setting" and press OK to enable setting the drop.
10. Use the UP and DOWN arrows to adjust the screen
drop to the desired amount, up to 12" to the bottom
of the cassette.
DO NOT set the drop more than 12"(4" for Short
Throw) from the cassette. Doing so can damage
the screen material.
11. Once the viewing area is positioned and the drop
is correct, press the OK button to save the new
lower limit and drop.
12. Turn the setting tool off.
13. Disconnect the RS485 cable from the Setting Tool.
14. Reconnect the RS485 cable to the control system.
RS485 LV Motor / Programming 27