Storage And Transport - Screen Innovations Solo Pro Installation Instructions Manual

STORAGE AND TRANSPORT

Before storing or transporting, make sure the screen is
fully rolled up. Disconnect the motor power supply and
any control wiring to make sure the screen does not
deploy and get damaged accidentally.
It is preferred to store or transport your Solo Pro
horizontally. Shock and vibration experienced during
transportation may shift the screen material and cause
wrinkles. If this occurs, the wrinkles may be removed
in most cases by manually redistributing the material
back with the following steps:
1. With the screen lowered completely, look at the
back of the weight bar. If you see set screws,
loosen all of them 1 turn. If there are no set screws,
skip this step.
2. Bump the bottom of the weight bar up several
times along it.
RS485 LV Motor / Storage and Transport
3. With one hand grab over the center of the weight
bar and hold the material at the bottom of the
screen.
4. With the other hand lightly grab the screen material
around the weight bar and gently slide your grip
toward the edge of the screen to redistribute the
material.
5. Repeat the process to move the material from the
center toward the other edge.
6. The wrinkles may not fall out immediately if the
screen has been stored in a wrinkled condition. If
you have wrinkles remain after an hour, then call
us for further instructions.
7. If the wrinkles are gone, snug up the weight bar set
screws finger-tight (approx. 1 in-lb.).
Storage temperature is important for the screen
material. Store it between 0°C and 50°C.
28 RS485 LV Motor / Storage and Transport 29