Switching On And Off The Projector - Sim2 HT 280E User And Installation Manual

Avoid light shining directly on the screen during projection as
this will reduce contrast and black level detail on the projected
image. For the true cinema experience best results are achie-
ved with little or no ambient light.

5 SWITCHING ON AND OFF THE PROJECTOR

CAUTION: Connect the projector to a power supply
with a nominal voltage within the following values:
100-240 Vac, 50/60 Hz. It must be earthed (Fig.
13).
���������������
����������������
������������
������������
�������
����������
Upon switch on (in position I) the projector will initialise (red
and green LEDs on). Followed by stand-by mode (red LED
on) (Fig. 14).
N : po
N T IO
A T T E n co nt
ec tio
la pr ot pa r un
ac er
re m pl s ca ra
m em
et de
: fo r co
T IO N
C A U fir e, re
ris k of sa m e
w ith
on ly
tin g fu
an d ra
et tr e
m pr om
nd e
pa s co
d' in ce
ur ne re sq ue
e ty pe
re le s
m em
e de
fu si bl
ns t
tiq ue n ag ai
ct er is
ec tio
d pr ot
nt in ue
pl ac e
ty pe
se .
Furniture and other objects with reflecting surfaces, as well as
light coloured walls should be avoided, as they are likely to
interfere with the screen's characteristics.
SWITCH ON FROM STAND-BY
By remote control: press one of 1...9
By keyboard: press Up or Down Arrow.
Fig. 13
When switching on from stand-by, the projector will turn on the
lamp; after a brief warm up period the image will be displayed
(green LED on).The input automatically selected will be the last
one memorised prior to switch off (Fig. 15).
You may experience difficulties switching on the projector
shortly after switching off: the lamp may fail to come on as it is
too hot. Just wait a few minutes to cool it down.
Fig. 14
9
Fig. 15