Switching Off And Returning To Standby; Connections - Sim2 D80 User And Installation Manual

SwiTChiNg Off AND RETURNiNg TO STANDBY

With the remote control: press
With the keypad: press .
When switching off, the projector goes into stand-by mode and
stores the input selection at the time of switch-off.
The fans keep running until the lamp cools down (green and

6 CONNECTiONS

To obtain the best performance from your projector, we recom-
mend the use of good quality "video cables" to the various
signal sources (75 ohm Impedance).
Poor quality cables will cause inferior picture performance.
For optimum connectivity we recommend you follow these
simple steps:
- With exception of coaxial RCA/Phono type connectors,
always double-check that the plug is inserted the correct
way round to avoid damaging the plugs or the sockets on
the projector (Fig. 15).
- Remove cables by the plug and do not pull on the cable
itself.
- Avoid tangled cables.
.
Status Led green
Initialisation
Standby
On
Cooling
Damage sensors
temperature
: O : On
red leds on), after which they automatically switch off. Do not
switch off the projector with the power switch until the fans have
stopped running.
Led rosso
: Flashing
- Position the cables carefully to avoid a trip hazard - espe-
cially in low light areas.
Table 1
ce n d e
u e d 'in
p e
s re sq m e ty
N :
N T IO tr e le e m e
A T T E n co n b le d
te ct io n fu si
p a r u iq u e in st
la p ro n a g a
la ce r ct e ri st
s ca ra te ct io
re m p
e d p ro
m e m
n tin u
e t d e
: fo r co
T IO N
ce
re p la
C A U
f fir e ,
ty p e
ri sk o
sa m e
w ith se .
o n ly
tin g fu
a n d ra
75
Fig. 15
11