Switching The Projector On And Off; Switch On From Standby - Sim2 D80 User And Installation Manual

5 SwiTChiNg ThE PROJECTOR ON AND Off

wARNiNg: Connect the projector to a power supply with a
nominal voltage within the following values: 110-240 V AC,
50/60 hz. it must be earthed (fig. 12).
Position I : on
Position O : off
Power switch
Fused power
socket
Power plug
In position i the projector will initialise itself (red and green leds
on) and then goes into standby mode (red led on) (Fig. 1).
A T T E
la p ro
re m p
e t d e
C A U
ri s k o
o n ly
10
m e tt re
o m p ro
d e
p a s c 'i n c e n
q u e d
u r n e
p e
N : p o s re s m e ty
N T IO tr e le e m e
n c o n
ib le d
te c ti o n fu s
g a in s t
p a r u ti q u e
c te ri s ti o n a
la c e r
ro te c
s c a ra
u e d p
m e m
o n ti n
: fo r c
T IO N c e
re p la
f fi re ,
ty p e
s a m e
w it h

SwiTCh ON fROM STANDBY

With the remote control: press one of the keys 1...9 or with 0.
With the keypad: press the ON/OFF button.
Fig. 1
When the unit is switched on from standby the lamp switches on;
after a brief period of warming up, the image displays (green
led on). The projected image comes from the input selected
when the unit was last switched off (Fig. 14).
If a very short time has passed since the unit was last switched
off, the lamp may not switch on beause it is too hot.
Just wait a few minutes for the lamp to cool down sufficiently.
Fig. 1
Fig. 14