Step 11 - Adjust Factory- -Installed Options; Step 12 - Install Accessories - Bryant 551J*07A/G Series Installation Instructions Manual

Step 11 — Adjust Factory- -Installed Options
Smoke Detectors —
Smoke detector(s) will be connected at the Controls
Connections Board, at
Shutdown". Cut jumper JMP 3 when ready to energize unit.
EconoMi$er IV Occupancy Switch —
Refer to Fig. 63 for general EconoMi$er IV wiring.
External occupancy control is managed through a
connection on the Controls Connections Board.
If external occupancy control is desired, connect a time
clock or remotely controlled switch (closed for Occupied,
open for Unoccupied sequence) at terminals marked
OCCUPANCY on CTB. Remove or cut jumper JMP 2 to
complete the installation.
Step 12 — Install Accessories
Available accessories include:
Roof curb
Thru- - base connection kit (must be installed before unit
is set on curb)
Electric heaters and single- - point connection kits
Manual outside air damper
Two- - position motorized outside air damper
Low ambient controls
Economizer
Fig. 63 - - EconoMi$er
terminals marked "Smoke
2 Position Damper
R
IV Wiring
Thermostat / sensors
EconoMi$er2 (without control/for external signal and
integrated barometric relief)
EconoMi$er2 (without control/for external signal)
Power exhaust
Electric heaters
Single point kits
Differential dry- - bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
CO sensor
2
Louvered hail guard
Phase monitor control
Winter Start kit
Refer to separate installation instructions for information
on installing these accessories.
50
Unit Without Economizer or
2 Position Damper
C160123