Table of Contents
Advertisement
³
Fill the mixer attachment
ter and add a few drops of mild detergent. Clo-
se the lid (2) and place the mixer attachment
on the motor block
mains power socket and activate the Ice
Crush/Clean switch, causing the cutters to rotate
in the water with maximum revolutions.
Afterwards, rinse the mixer attachment
lots of clean water, such that all soap residues
are removed.
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
r
ters
) from the the glass part:
³
Remove the mixer jug
u
.
³
Turn the plastic element
e
ment
anti-clockwise, such that it allows itself to
be released from the glass element
Attention!
Take care with the cutters
Risk of injury!
³
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
³
Place the plastic part
e
with 750 ml of wa-
u
. Insert the plug into a
e
e
(with the cut-
e
from the motor block
of the mixer attach-
.
. They are very sharp.
of the mixer attachment
e
back onto the glass part
tachment
e
aling ring
Cleaning the motor block
³
Use a dry cloth or, at the most, a lightly moistened
one for cleaning the plastic surfaces.
³
with
At every cleaning check that the contact switch
in the receptor for the mixer jug
ked by soiling residues. If you cannot dislodge
any blockages with the corner of a piece of pa-
per, make contact with Customer Services. Un-
der no circumstances should you use a hard ob-
ject, this could damage the contact switch.
³
Remove any possible residues on the underside
of the motor block
stiff bristled brush. Ensure that nothing can enter
through the ventilation opening of the appliance.
After cleaning
Allow all parts to dry well before re-assembling and
re-using the liquidiser.
Storage
³
If you do not intend to use the liquidiser for an
extended period, clean it thoroughly (see chapter
"Cleaning").
³
Wrap the power cable
i
rage
³
Store the liquidiser at a cool and dry location.
- 6 -
e
and screw it tight. Ensure that the se-
is correctly fitted.
u
only with a dry cloth or a
y
around the cable sto-
on the base of the motor block
of the mixer at-
e
is not blok-
u
.
Advertisement
Table of Contents
