Cleaning The Motor Block; After Cleaning; Storage - Silvercrest 339532 1910 Operating Instructions Manual

NOTE
4) Dry all parts thoroughly before reassembling them.
5) Re-attach the lower plastic part C of the blender 3 to the upper plastic part
A of the blender 3 and turn it clockwise.

Cleaning the motor block

1) Use a dry or no more than slightly moistened cloth to clean the plastic
surfaces.
2) When cleaning, always check that the contact switch in the fitting for the
blender 3 is not blocked by soiling residues. If you cannot dislodge any
blockages with the corner of a piece of paper, make contact with Customer
Services. Do not use any hard objects, these could damage the contact
switch.
3) Remove any possible residues on the underside of the motor block 6 with a
dry cloth or a stiff-bristled brush only. Ensure that nothing can get in through
the ventilation openings of the appliance.

After cleaning

Allow all parts to dry well before reassembling and reusing the liquidiser.

Storage

1) If you do not intend to use the blender for an extended period, clean it
thoroughly (see chapter "Cleaning").
2) Wrap the power cable around the cable retainer 7 on the base of the
motor block 6.
3) Store the blender in a cool and dry location.
SSM 600 B2
You can also clean the upper plastic part A of the blender 3 and
the cutting blade 4 with the lower plastic part C in your dishwasher.
GB │ IE │ NI │ CY │
15 ■