Table of Contents
Advertisement
Removing the mixer
When the processing of the foodstuffs is complete:
³
Always first place the switch
position ("0") and remove the power plug.
³
Wait until the motor has come to a complete
standstill before lifting the mixer jug
up. It does not need to be turned.
Useful tips
– The best results when blending firm ingredients
are achieved by placing small portions one after
the other into the mixer jug
ting a single large portion.
– When processing firm ingredients, cut them into
small pieces (2-3 cm).
– When mixing liquid ingredients begin first of all
with a small measure of fluids. Gradually add
more fluids to the mixture through the filling cap.
– The appliance can be stabilised by placing your
hand on top of the closed liquidiser during opera-
tion.
– For the stirring of firm or very viscous foodstuffs
it can be beneficial to use the impulse-operation,
which helps avoid a blocking of the cutters
Notice
Do not use the appliance to crush grains of cooking
salt, refined sugar or white sugar. For example, to
make powdered sugar.
t
into the OFF
e
straight
e
instead of inser-
r
.
- 5 -
Cleaning
Caution!
Before starting to clean the liquidiser and its
components:
• Ensure that the motor is switched off and the
power plug removed from the socket.
Under no circumstance may the motor block
u
be submersed in water or other fluids.This
could result in you receiving a fatal electric
shock and the appliance could be damaged.
• Never open the housing of the appliance. This
brings with it the risk of receiving a fatal electric
shock.
• Never disassemble the cutters
ach into the mixer jug
tremely sharp!
• Do not use solvents or abrasive cleaners on the
plastic surfaces, they could be damaged by them.
Cleaning the mixer
³
So that you do not injure yourself on the cutters
r
, clean the mixer jug
handled dishwasher brush.
³
In the event of stubborn soiling, you can also cle-
an the mixer attachment
For this, take the mixer attachment
described later. Otherwise, tensions may occur
during the washing process and the mixer at-
e
tachment
could be damaged.
³
w
Clean the lid
and the filling cap
washer or with the normal washing up.
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
r
and never re-
e
r
. The cutters
are ex-
e
only with a long
e
in the dishwasher.
e
apart, as
q
in a dish-
Advertisement
Table of Contents
