Connecting The Display; Recommendation To Use More Than One Unit - Advan AMM215WTTP User Manual

Connecting the Display

To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC plug to the power connector on the monitor and the other end into an
electrical outlet (8.1).
3. Connect the D-SUB or DVI cable from the display's D-SUB or DVI input connector to the
D-SUB or DVI connector of your host computer and tighten the screws (8.1).
4. Connect the USB cable from the USB port of your display to the USB port (8.1) of your
computer.
5. Configure the touch screen. Refer to the "Touch Screen Driver Installation" section on
page 16.
6. Once the touch screen is configured, the monitor is ready for use.
Note:
Avoid placing the monitor against a bright background or where sunlight or other light
sources may reflect on the area of the monitor. Place the monitor just below eye level.
To ensure the LCD display works well with your computer, please configure the display mode
of your graphics card to make it less than or equal to 1920 x 1080 resolution and make sure
the timing of the display mode is compatible with the LCD display.
We have listed the compatible "Video Modes" of your LCD display in the appendix
(on page 24) for your reference.
External power supplies applicable: Bridgepower / BPM050S12F09

Recommendation to Use more than One Unit

As unforeseen situations can occasionally occur with the monitor, when the display is used
please use a safety control. It is strongly recommended the user uses more than one unit or
prepares a spare unit in case there is an emergency.
On Burn-in
Permanent burn-in may occur from the followings:
‧ Displaying color bar or static images repeatedly or for a long period of time.
‧ Using the unit repeatedly in a high temperature/ high humidity environment
‧ Displaying an image smaller than the monitor continuously.
16