Silicon Laboratories C8051F04X-DK User Manual page 10

Development kit
Table of Contents

Advertisement

C8051F04x-DK
6.6. Controller Area Network (CAN) Interface (J25)
A DB-9 (J25) connector is provided to facilitate serial connections to the CAN interface on the C8051040. In addi-
tion, when a shorting block is installed on header J7, writing a logic 'high' to port pin P4.2 will place the CAN trans-
ceiver in low-current standby mode. Also, resistor R12 may be replaced with a higher value to control the slew rate
of the CAN_H and CAN_L signals. See the TI SN65HVD230 data sheet for further information. Table 5 listes the pin
descriptions for J25.
6.7. PORT I/O Connectors (J12 - J19)
In addition to all port I/O signals being routed to the 96-pin expansion connector, each of the eight parallel ports of
the C8051F040 has its own 10-pin header connector. Each connector provides a pin for the corresponding port
pins 0-7, +3.3VDC and digital ground. Table 6 defines the pins for the port connectors. The same pin-out order is
used for all of the port connectors.
Table 6. J12- J19 Port Connector Pin Descriptions
6.8. VDD Monitor Disable (J23)
The VDD Monitor of the C8051F040 may be disabled by moving the shorting block on J23 from pins 1–2 to pins 2–
3, as shown in Figure 4.
10
Table 5. CAN Connector Pin Descriptions
Pin #
2
7
3, 6
1, 4, 5, 8, 9
Pin #
Description
1
2
3
4
5
6
7
8
9
+3 VD (+3.3 VDC)
10
GND (Ground)
MONEN
VDD Monitor Hardware Setup
Figure 4.
Rev. 0.6
Description
CAN_L
CAN_H
GND (Ground)
Not Connected
Pn.0
Pn.1
Pn.2
Pn.3
Pn.4
Pn.5
Pn.6
Pn.7
1
2
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C8051F04X-DK and is the answer not in the manual?

Questions and answers

Table of Contents