Table of Contents
Advertisement
contains chemicals known [to the
State of California] to cause can-
cer, birth defects or other repro-
ductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and ce-
ment or other masonry products
• Arsenic and chromium from chemi-
cally treated lumber
Your risk from these exposures var-
ies, depending on how often you do
this type of work. To reduce your
exposure to these chemicals: work in
a well ventilated area, and work with
approved safety equipment, such as
those dust masks that are specially
designed to filter out microscopic
particles. (California Health & Safety
Code § 25249.5, et seq.)
29.
WarnInG: Handling the cord on
this product will expose you to
lead, a chemical known to the
State of California to cause cancer,
and birth defects or other repro-
ductive harm. Wash hands after
handling. (California Health & Safety
Code § 25249.5, et seq.)
30.
the warnings, precautions, and
instructions discussed in this in-
struction manual cannot cover all
possible conditions and situations
that may occur. It must be under-
stood by the operator that common
sense and caution are factors which
cannot be built into this product, but
must be supplied by the operator.
SKU 66660
For technical questions, please call 1-800-444-3353.
preventing Kick Back
Kick back is an extremely
dangerous action which can
cause serious injury.
1.
Kick back occurs when the Blade
binds in the work material during
operation. The Blade stops instantly,
causing the tool to recoil back toward
the operator. The work material may
also recoil at an unpredictable angle.
Kick back can cause serious personal
injury or damage to property.
2.
Never place your hand or fingers
behind the saw during use. If the
saw kicks back, your hands can be
seriously injured. During use, always
hold the tool firmly with both hands
on the two handles.
3.
It is important to be aware of the
possibility of kick back at all times
when using the tool. Use safe prac-
tices at all times to prevent kick back,
and to protect yourself and others
from injury, should it occur.
4.
Kick back can be caused by the
blade being misaligned with the
work material. Prevent misalignment
by always clamping the work mate-
rial to a stable work surface. Always
make a cut in a straight line, never
try to cut a curve with this tool. When
making cuts over 1 foot long, always
use a rip fence or straight edge to
ensure a straight cut.
5.
Kick back can be caused by at-
tempting to cut too much material
at once. Do not force the tool, allow it
to work at a slow and steady pace. If
you are forcing the tool, you will hear
Page 7
Advertisement
Table of Contents
