Introduction; Contents - ABB Ekip E-Hub Manual

Introduction

1 - Contents

Overview This manual describes the characteristics of Ekip E-Hub, including:
Recipients
In accordance with standard IEC 60050, this manual is aimed at two user profiles:
Distribution and
For optimum installation and configuration of Ekip E-Hub in the plant, the following tasks
organization of
should be performed in sequence, which are available and distributed in the technical
information
product documentation (User Manual and Getting Started):
Number
1
2
3
4
5
6
7
2TFP900034A1001 ECN000087106 Rev. A
1. Introduction
2. General View
3. Settings
4. Provision
5. Diagnostic
6. Troubleshooting
• expert persons, in electric environment (IEV 195-04-01): persons with sufficient
training and experience to enable them to perceive the risks and avoid the hazards
potentially created by electricity
• persons trained in an electrical environment (IEV 195-04-02): persons suitably
informed or supervised by electrical technicians to enable them to perceive the
risks and avoid the hazards potentially created by electricity
IMPORTANT: in this manual the tasks are specifically indicated that can be
performed by trained persons in an electrical environment. All the remaining
tasks described in the manual must be performed by trained persons in an
electrical environment.
ABB accepts no liability for damage to property or personal injury due to failure
to comply with the instructions contained in this document.
Task
Consult the safety notes
Check operating conditions
Check material received
Installation instructions
Parameters configuration
Provision
Monitoring
Document
1SDH002006A1001-A.pdf
Ekip E-Hub | 4