ABB Ekip E-Hub Manual page 17

Network
Settings
Fig. 10
Parameters
Parameters
Force Static IP Address
Static IP Address
Static Network mask
Static Gateway
Optional DNS Server 1
Optional DNS Server 2
DHCP enable
DHCP server IP range
begin
DHCP server IP range end
2TFP900034A1001 ECN000087106 Rev. A
• Click Communication > Parameters
• The custom should be careful if wants to change the LAN2 IP address. Make sure
the input static IP address and the DHCP server IP range are correct and in the
same LAN before save the configuration.
• Click Save the configuration.
NOTE: Please always remember the input LAN2 static IP address before save the
changes.
Description
Switch on/off to use static IP address.
To make the Static setting available,
please enable the Force Static IP
Address.
IP address on LAN port
Subnet mask for LAN port
Default gateway IP address
DNS Server IP. Keep default value for LAN2
DNS Server IP. Keep default value for LAN2
Enable/Disable DHCP server for LAN2
IP range begin that DHCP server dynamic
distributing
IP range end that DHCP server dynamic
distributing
Default
Off for LAN1
On for LAN2
0.0.0.0 for LAN1
10.86.92.1 for LAN2
255.255.255.0
0.0.0.0
0.0.0.0
0.0.0.0
On
10.86.92.100
10.86.92.255
Ekip E-Hub | 17