Mac Os X Instructions; Open Configuration Web Page - ControlByWeb WebRelay X-WR-1R12-1I5-5 User Manual

WebRelay Users Manual
ping -s 102 10.10.10.40
4. Proceed with the WebRelay setup in Section 3.
Once setup is complete, it may be necessary to clear the 'arp' cache to configure additional devices.
This is necessary because each unit has the same default IP address, but a different unit serial
number (MAC address). Clearing the arp table can be done by typing sudo arp -d -a in the
command prompt window.

Mac OS X Instructions

1. Open a terminal.
Note: The terminal is in the "Utilities" directory, which is in the "Applications" directory.
2. Type:
sudo arp -s {new IP address} {serial number of the WebRelay }
Administrator password may be required.
Note: IP address format is xxx.xxx.xxx.xxx. The serial number can be found on the label on the
module board. The format is ss:ss:ss:ss:ss:ss.
For example, to set the WebRelay (with serial number 00-0C-C8-01-00-01 ) to 10.10.10.40 the
following command would be used:
sudo arp -s 10.10.10.40 00:0c:c8:01:00:01
3. Next, type:
ping -s 102 {new IP address}
For example, if the new IP address is 10.10.10.40, the following command would be used:
ping -s 102 10.10.10.40
4. Proceed with the WebRelay setup in Section 3.
Once setup is complete, it may be necessary to clear the 'arp' cache to configure additional devices. This
is necessary because each unit has the same default IP address, but a different unit serial number (MAC
address). Clearing the arp table can be done by typing sudo arp -d -a in the command prompt
window.

2.3.3 Open Configuration Web Page

Once the network is set up, open the setup pages by typing the following URL into the browser:
http://192.168.1.2/setup.html
Note: If option 1 above was used for initial configuration, replace the IP address given here with the
newly assigned IP address.
Xytronix Research & Design, Inc. Page 33