Kogan KAGFLWASH9A Owner's Manual page 17

Cleaning the drawer housing
Use a bottle brush to remove detergent residues
inside the drawer housing.
Use pointed nose pliers to withdraw the plastic filter.
Clean, put back and secure. These filter should be
checked every 6 months or so, or more often if there
are frequent interruptions to the water supply.
The filter must be put back in place after cleaning.
1. Disconnect the machine from
the mains electricity supply and
open the lower cover with a
screwdriver.
The filter should be cleaned every 2 months or so, or when there
is fault that the "E03" is on the screen.
Important:
If the machine is exposed to temperatures below 0°C, certain precautions
should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and position the end of this
hose and that of the inlet hose in a bowl. Run the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure that the room
temperature is above 0°C.
2. Place a container under the pump.
Unscrew and remove the filter.
3. Clean the filter carefully.
14